If there is still no display showing, check if video was shown during the POST routine.If the Self-Test box does not appear on the display, replace the display with a verified working unit.A Self-Test box should appear on the display. Remove the data cable from the computer.Ensure that the correct Input Source on the display is correctly selected.Ensure that the display data cable is not damaged and replace if necessary.Ensure that the display is connected to the correct port and turned on.The diagnostic lights are not lit after the computer successfully boots to the operating system but there is no display showing. The desktop computer is in a normal on condition. Some Desktops do not have an F12 key, to access the boot options you have to press the ( zero) key at the Dell logo screen.įor information about running and using the ePSA Diagnostics, check out our: Enter the One Time Boot Menu and use the arrow keys to select Diagnostics and press enter. For a Desktop at the Dell logo screen, tap the F12 key.Reconnect one at a time and check if the computer functions. If the computer is not beeping and the Diagnostic LEDs are not flashing or lit? Unplug all connections and remove all media communication devices (for example external monitors).If you cannot find the beep or LED diagnostics code your personal computer displays in any of the media above, contact Dell Technical support directly.For information about Desktop LED codes, see the table in your computers User Manual or check out these articles:ĭiagnostic Indicators (Inspiron Desktops),ĭiagnostic Indicators (OptiPlex Desktops),ĭiagnostic Indicators (Dell Precision Workstations.).Understanding Beep Codes on a Dell Desktop or All-in-One PC For information about computer beep codes, see the table in your computers User Manual or have a look at this article:.Remove all attached components, reattach the PSU cables and using the PSU test button, install each component individually to test. If after removing the cables from the system board and the PSU LED illuminates, one of the attached devices or components could be faulty. If the LED still does not illuminate when the test button is pressed, the PSU is possibly faulty. If the PSU LED does not illuminate, remove the PSU cables from the system board and test again.Ensure that the power cable is connected to the supply and press the test button to test the PSU. A test button and LED are on the side of the unit where the AC plug is located.
0 Comments
Leave a Reply. |